|
  
|
||
|
|
||
ExSync can run in single cycle sync mode or continuous sync mode.
Single Cycle mode
This is where a data selection is synchronized once.
This is selected by clicking the Green traffic light button:-
Continuous mode
This is where a data selection is synchronized continuously.
This is selected by clicking the Green traffic light button:-
When running in continuous mode the tables will all finish at different times depending on the volume of data to be converted. When a table completes a cycle it will simply start all over again.
To Stop continuous mode simply click the Red traffic light again and as the cycle completes the status of the selection will change from 'Active' to 'Off'
see also Starting & Monitoring Synchronization
